|
Drive function
|
Operating instructions
|
|
Output current seting
|
By the SW8-SW10 three DIP switches to set the driver output current. Peak output current setting of specific, please refer to the drive panel diagram.
|
|
Set the number of micro-step breakdown
|
The SW1-SW5 five DIP switches to set the number of micro-step. Specific micro-step breakdown of the number of settings, refer to the drive panel diagram.(SW4,SW8 is vacant, no adjustment)
|
|
Single and double pulse setting
|
SW7 set the pulse mode, set the double pulse mode ON, OFF pulse + direction mode.
|
|
Self-test function settings
|
When SW1-SW5 are all OFF when the drive with the internal 1KHZ pulses to detect whether the motor is normal.
|
|
Automatic half current function
|
Users can set the drive SW6 half current function. "OFF" means half the quiescent current to the dynamic current, the pulse current is automatically reduced to 0.5 seconds to stop about half; "ON" said quiescent current and dynamic current is the same. SW6 should be set to a general user "OFF", the motor and the drive to reduce the heat generation, improved reliability.
|
|
Signal interface
|
PUL + and PUL-control pulse signal is not a dispute and the negative side;
DIR + and DIR-signal for the direction of the positive terminal and a negative terminal;
ENA + and ENA-enable signal to the positive terminal and a negative terminal.
|
|
Motor Interface
|
A + and A-connected motor phase winding; B + and B-phase winding is connected to the other motor. Need to reverse, you can swap one phase winding.
|
|
Power interface
|
DC power supply, voltage recommended 110VAC-220VAC, Power greater than 500W.
|
|
Indicator
|
Two lights. The power indicator is green, the drive is powered on the green light. Fault indicator is red, when an overvoltage, overcurrent fault, flashing or steady red light, when the fault is cleared off the red power on again.
|
|
Installation instructions
|
Drive external dimensions: 198*76*130mm, see specific Dimensions. Note that aside more than 10cm of space to facilitate cooling. It should be installed close to facilitate cooling the metal cabinet.
|
